Leaking copper pipes

Leaking Copper pipes are amongst one of the most common household problems.

Luckily for you, there’s no need to waste precious time and money on calling out a professional just yet. There’s a good chance that you can remedy this yourself at home and seal those pinholes up before they become a dire problem! However, if you feel more comfortable calling a professional plumber, we can recommend you the company named Genesis Plumber, It’s a plumbing company based in El Paso, Texas. You can find more info about the company on the website: http://Plumber-ElPaso.com.

You may have to purchase some small parts that you might not have at home, but rest assured that it’s a damn lot cheaper than calling out a plumber.

Though I must specify that the following fix is more of a temporary one. A quick fix that you can do at home quickly until you can use a more substantial repair at a later date.

Very quick and very rudimental, yet still quite effective.

You will need:

  • Putty knife
  • Epoxy resin
  • Piece of rubber (to cover the pinhole leak)
  • Jubilee clip/clamp
  • Water resistant tape

Step 1: Turn the Water Off

According to Popular Mechanics, the first action you should undertake is to make sure the water valve to the pipe is shut off.

It is extremely difficult to mend or repair anything when there’s water shooting in your face so you do self a favor and turn it off.

Now turn on the connected faucet so that the remaining water that’s in the pipe is drained out and so there’s no danger of further leaking while you work.

plumber

Step 2: Dry pipes

Now that the inside of the pipes is devoid of water, you want to give the outside the same treatment. It might be a good idea to put a towel down around the work area just in case of any nasty surprises.

Take a dry cloth and wipe down the exterior of the pipe. The pipe must be completely dry before you can continue.

Step 3: Cover The Pinhole

Use your putty knife to slide a small amount of epoxy over the entire leaking area. After this, take your rubber and place it directly over the pinhole. So if the water were turned on again, you would be able to stop the water from spurting out.

You will now put the metal clamp over the rubber to bend it down, so the rubber is kept firmly in place.

Tighten said clamp and allow the rubber to set for about an hour.

After that hour has passed, remove the clamps and replace it with water resistant tape. The rubber itself should now be firmly set and fine as it is, but the tape gives it a second layer of protection in case the water manages to find a gap in the rubber to sneak through.

Step 4: Turn the Water Back On

Switch the water valve back on.

If the following steps have been done correctly, you will find that the leak will be fixed and your pipes working like new!

Again, please note that this is a temporary quick fix. You should closely monitor the situation afterward to decide whether to take further action that requires more professional expertise. Also, take care to note if there’s anything surrounding the pipe area that may have caused the problem externally, and thus could cause the issue again.